Launch the Cinedeck Client Software
| Info |
|---|
Please make sure your start the Cinedeck server and the Server software so the client can connect. |
For the initial login, select the "Super User" icon.
...
The Software will prompt you to Connect to a Deck, click Connect.
...
| Info |
|---|
If this pop up does not appear it means the client already has settings from a previous session if you would proceed without any settings go to Clearing the Client UI Cache |
...
The Add deck dialog will appear, where you need to add the IP address of the Cinedeck server you want to control from the client.
...
Click on Presets on the top left
...
(fig1)
Double click on the Default Preset (fig2)
...
Select the encoder settings Icon on viewer 1 to configure your source and record info
...
Next you need to setup up your record codec/s and record destination/s from the dropdowns.
Click on the Primary encoder tab in the encoder window and select
Select your codec , (fig1)
Select codec Quality and Wrapper from the dropdowns.
...
(fig2)
Select Wrapper (fig3)
...
At the bottom of this window you can select your record destination
...
You can do the same for the Proxy encoder or disable it by un-checking the enable box. (fig4)
Close the encoder setting tab by clicking on the X on the top leftright.
Now you are ready for your first record.
...
For more information on setting your folder and file naming please see File Naming & Paths Overview
For more info on working with presets see Presets Overview5 Easy steps to creating a recording using the Cinedeck Client
...